You are searching about A Need-Payoff Question Could Also Be Called A Value Question, today we will share with you article about A Need-Payoff Question Could Also Be Called A Value Question was compiled and edited by our team from many sources on the internet. Hope this article on the topic A Need-Payoff Question Could Also Be Called A Value Question is useful to you.
How to Paper Tune Your Bow
In my broadhead tuning feature, I wrote about the steps needed to tune your bow and arrows. In this column, I want to go into more detail about the important paper tuning process. This is the easy technique to make the adjustments needed for laser-straight arrow flight.
You need a new shot on paper with no outside interference. Place the tuning paper at least 3 feet from the target so that the arrow has no chance of hitting the target before it passes through the paper. Stand or sit about six feet from the paper when shooting your bow. Make sure the paper is about shoulder height so you can use regular shooting form. This is important.
Since paper tuning is all about experimenting with your bow setup and your shooting form, you need to focus on making perfect shots or you’ll be chasing your tail, adjusting your bow if your shooting type is really the problem. If you grip when you trigger the release or punch the trigger, you will likely see tears even if your bow is perfectly positioned. Keep your grip very relaxed throughout the shot and maintain a steady follow-through until the arrow hits the target.
Understanding Your Tears
After looking at the paper, post-shot, you can see a round hole where the field point went through and some kind of tear due to the vanes and the last part of the bow. The value of paper tuning depends on your ability to read these tears and make the right adjustments to your bow and shooting form to cut them. Your target is around the “bullet” hole with 3 narrow cuts radiating outwards due to the vanes. Such a hole is the result of an arrow that actually flies, with the neck following directly behind the point. Any deviation from this perfect flight will deprive you of accuracy and penetration when hunting.
There are 4 reasons your archer may be throwing a long tail arrow. 1st, the nock point can be very high on the thread. 2nd, some may be too low. 3rd, arrows can hit others, causing the arrow to deflect. And 4th, the bow cam timing can be off, causing the nock to move up as the string moves.
If a modern compound bow is properly setup, the arrow will make a 90-degree angle to the string and cross the rest right in the middle of the hole that places the rest. You can make small adjustments to the nock point to lower the tail (1⁄8 inch at a time), but don’t make major changes. If you need to make a lot of changes to see the change in tears on paper, the problem is somewhere else: timing of the cam or useless contact with others.
If the grasses hit the rest, you should see objects or marks on one of the grasses. If not, you may be out of touch. But, to be sure, try rotating the bow nock to change the orientation of the vanes relative to the others. That makes a difference. If you can’t remove the contact this way, consider a similar test or increasing the tension on your activation cord (on a drop-away rest) to see if that helps by getting the launcher out earlier.
If the high tail tear persists after adjusting the nicking point and eliminating contact, the issue likely involves the timing of the bow’s cam. Unfortunately, I don’t have room here to dive into this topic, but I will cover it in an accompanying video on the website. Adjusting cam timing can be complicated, and unless you know what you’re doing, you should take the bow to a good archery shop for help.
Low arrow flight is rare and usually the result of an arrow with incorrect cam timing. It’s also possible that your nocking point is too low or your rest is too high, but you can quickly control that by raising your nocking point 1⁄8 inch to 1/4 inch. Again, if the prognosis is cam timing, your best solution is to seek professional help.
Tail-Left and Right Tears
Paper tears on the side can be difficult to eliminate because they have four possible causes, only two of which are easy to fix. I’ll start with the easy ones. First, move your rest toward.
The bow if the bow is torn to the right or from the bow if it is torn to the left. Sometimes you get a strange interaction with the side rope movement and your results don’t make sense. For that reason, you should also try moving the others slightly in the opposite direction just to prevent some oddball harmonics in the string.
If that doesn’t do the trick, consider a bow with a different spine – or just a different brand. I’ve had arrows that produced good arrow flight with one arrow and not the others, even though they were about the same stiffness. A little experimentation in the archery shop can eliminate a lot of frustration.
Now for the hard fix. Sideways travel of the string can cause left or right tearing that is impossible to fix, short of making mechanical adjustments to the bow to ensure that the cams start vertically and stay vertical when you draw the string. . This is a difficult fix for most bow hunters, it’s time to visit the pro shop for help. But before you do, make sure your shooting form isn’t the cause of these side tears.
If you flinch during the shot, remove the grip when you release, use a grip position that creates torque on the riser or apply side pressure to the string with your release, it will lead to poor arrow flight – usually approx. paper tear on side.
Unfortunately, you have to do your shooting form with a lot of attention to detail before you can tell that the problem is with the bow. It can take weeks, even months, as you work to improve your form. I chased the tuning problems for weeks to finally realize it was something I was doing. Sure, I learned a lot about archery in the process, but I also lost a lot of hair!
Tuning a bow is not a dark science, but it does require some effort, and possibly, some expert help. But the payoff is worth the investment. Watching your arrows fly like lasers is the true magic of archery.
The Paper-Tuning Fixture
You don’t need a fancy hook to properly tune your bow. Although many pro shops have elaborate frames dedicated to tuning paper, you can get by with a simple cardboard box. Cut a hole smaller than a piece of copy paper in the floor of the cardboard box. You can tape the paper over the hole and shoot the box. Place it on something to achieve the correct height in front of the target and you are in business.
Another choice is even simpler; just buy a Paper Tune-It kit from Premium Review. The kit comes with a pre-made cardboard frame to hold your paper and 10 sheets of tuning paper with pre-printed instructions on how to correct imperfect tears.
Video about A Need-Payoff Question Could Also Be Called A Value Question
You can see more content about A Need-Payoff Question Could Also Be Called A Value Question on our youtube channel: Click Here
Question about A Need-Payoff Question Could Also Be Called A Value Question
If you have any questions about A Need-Payoff Question Could Also Be Called A Value Question, please let us know, all your questions or suggestions will help us improve in the following articles!
The article A Need-Payoff Question Could Also Be Called A Value Question was compiled by me and my team from many sources. If you find the article A Need-Payoff Question Could Also Be Called A Value Question helpful to you, please support the team Like or Share!
Rate Articles A Need-Payoff Question Could Also Be Called A Value Question
Rate: 4-5 stars
Search keywords A Need-Payoff Question Could Also Be Called A Value Question
A Need-Payoff Question Could Also Be Called A Value Question
way A Need-Payoff Question Could Also Be Called A Value Question
tutorial A Need-Payoff Question Could Also Be Called A Value Question
A Need-Payoff Question Could Also Be Called A Value Question free
#Paper #Tune #Bow